| Contact Us |
Bunting® Magnetics Co.
500 S. Spencer Ave.
P.O. Box 468
Newton, Kansas 67114-0468
U.S.A.
Fax (316) 283-4975
bmc@buntingmagnetics.com
Call us at (800) 835-2526 |
|
Bunting® Center-Flow Magnets are ideal for use in dilute-phase pneumatic
conveyor systems, handling materials that are non-abrasive or not
subject to damage by impact. It can be installed easily in any position
or angle with factory supplied compression couplings.
Recommended installation location is in long vertical runs. This
is because the air is more homogenous and distributed throughout
the cross section of pipe, exposing the conveyed material and any
tramp iron to the full surface area of the magnetic cartridge.
The Center-Flow Magnet can also be used in horizontal or sloping runs
if required by the application or desired by the user.
The magnetic cartridge of the Center-Flow Magnet has a tapered, exposed-pole
design with a stainless steel "nose cone" to direct the flow of
material around the magnet. The exposed poles provide superior holding
force. In addition, the poles are tapered to provide a static recess
area where small metal fines can collect and hide out of the air
stream to avoid wipe-off. The trailing end of the magnetic cartridge
is an active pole, and any tramp metal that might be swept down
will be collected on the "protected" end of the magnetic cartridge.
The magnetic cartridge is mounted to a removable cover for cleaning.
Simply unclamp the units cover and swing the magnetic cartridge
out on the support. Place the magnetic cartridge on a flat surface
with the nose cone up. Then wipe the tramp metal down the cartridge
and off the end. A "self aligning tab" is located on the opposite
end of the cover to assure proper alignment during reinstallation.
 |
|
|
|
|
|
|
|
